Dispensit 1092 and 1093 Valves

Precision Dispense Valve

Positive displacement metering rod valves for low to high viscosity materials

The Dispensit Model 1092 & 1093 rod positive displacement valves with luer lock needles. High precision repeatable shot-to-shot (1092) and bead (1093) volumetric dispensing. For tube dispense or pinch tube dispense.

  • For low to high viscosity materials with various wetted component configurations
    for abrasive filled, or corrosive materials
  • 1092 is a pneumatically-controlled valve with micrometer adjustable dispense volumes
    for accurate, repeatable shot dispensing
  • 1093 is a servo-driven valve for programmable, precise shot or bead dispensing
  • Pneumatic and electronic controls can be integrated for automated applications


  • Pnuematic drive with micrometer stroke adjustment (Model 1092). Servo motor drive (Model 1093)
  • Insensitive to changes in material viscosity-very thin to paste consistency.
  • Easily integrated with automated equipment.
  • Compatible with a wide variety of materials

Dispensit 1092

Maximum Ambient Temperature
Maximum Operating Temp
Maximum Outlet Fluid Working Pressure
2000 psi
Maximum Air Working Pressure
100 psi
Minimum Air Working Pressure
70 psi
Maximum Material Inlet Pressure
Metal Sleeves: 1200 psi
Plastic Sleeves: 400 psi
2.8 MPa, 28 bar
Supplied Air Requirements.
1 to 3 cfm at 80 psi to 100 psi
Shot Size Range (depending on metering rods selected)
0.024 cc to 9.600 cc
Maximum Cycle Rate (application dependent, heat required) .
Up to 60 cycles per minute
Dimensions (H x L x W), height to end of material inlet
Height 1092-10A-2: 12.53 in
Height 1092-10A-4: 17.16 in.
436 mm
Height 092-10A-6: 20.28 in.
515 mm
Length, non cycle detection: 8.38 in.
395 mm
Length, Detection: 9.13 in
232 mm
Single Needle Outlet (Standard): 1.75 in.
45 mm

Graco-supplied Feed System Assemblies (depends on selected options):

Smallest: 22.5 x 10 x 4 in.
572 x 254 x 102 mm
Largest: 60 x 28 x 19 in.
(1524 x 711 x 483 mm


6-7 lb
10-11 lb
14-15 lb
Wetted Parts
Metering Valve: Hardened steel, 303/304, 404, UHMWPE, Tungsten, carbide, fluoroelastomer, EPDM, PTFE, Acetal. Graco-supplied Feed System Hoses and Fittings: Mild steel, 303/304, PTFE, buna, polyethylene, polypropylene. Graco-supplied Tanks: Polyethylene, 303/304, mild steel